JST-XH 2.54 mm to Dupont 5P adapter cable - 20 cm, male/female
JST-XH 2.54 mm to Dupont 5P adapter cable - 20 cm, male/female
This goes with it
Pay in 30 days
Pay in 30 days
Description
Product overview
- Adapter cable with a JST-XH2 connector (54-pin) on one side and a Dupont connector (5-pin) on the other
- Length: 20 cm
- Male and female contacts on different sides
- Connects sensors and modules with different connector standards
- Flat ribbon cable design
Product description
This adapter cable connects assemblies with different connector types. One side has a JST-XH2 connector with 54 positions, while the other has a Dupont connector with 5 positions. The male and female contacts are distributed across different sides, so the cable only fits with a specific polarity.
The 20-centimeter length is sufficient for tight spaces in project setups and enables flexible component placement. The flat ribbon cable format takes up little space and is less likely to become tangled.
It is intended for connections between special sensors or battery packs with the JST-XH2 standard and common microcontroller boards or expansion modules that use Dupont connectors. A typical scenario is connecting a multicell battery to a balance charger or control electronics with Dupont sockets.
A prerequisite is that both devices actually use these two connector types; otherwise, the cable will not fit. Another adapter cable is required for other connector types or pin-count combinations.
Safety notice
The cable is intended only for prototype construction and testing and development purposes. Make sure to connect the cable with the correct polarity to prevent damage to the connected devices. Work on or near electrical installations is reserved for qualified electricians; if you are unsure about compatibility, consult a qualified electrician before connecting.
Scope of delivery
- 1x JST XH2.54 to 4P Dupont cable (20cm) male/female