2x AAA battery holder - 3 V, cable without connector

Product Overview

• Battery holder for two AAA cells, 3 V output voltage
• Attached cable without connector
• Stripped wire ends for direct soldering or connection
• Plastic housing with locking latch
• Battery holder diameter 13 mm, length approx. 45 mm

Product Description

This battery holder supplies circuits with 3 V DC from two AAA cells connected in series. The plastic housing holds both batteries and routes the output voltage through a permanently attached cable supplied without pre-assembled connectors. The stripped wire ends can be soldered directly to the circuit or connected via screw terminals, providing maximum flexibility during installation.

The battery holder is suitable for portable measuring devices, toy electronics, simple LED circuits, and small sensor modules. It is also well suited for prototypes that will later be integrated into a housing, as the cabled design allows the holder to be positioned independently of the rest of the circuit. The locking latch enables quick battery changes without tools.

Two AAA batteries are required for operation and must be purchased separately. The cable should be checked for mechanical damage before use, especially when the battery holder is installed in a moving system.

Safety Information

This battery holder is intended exclusively for building prototypes and for testing and development purposes. Do not use it for installation in the household electrical system. If you are unsure about integrating it into the circuit, consult a qualified electrician.

Scope of Delivery

• 1x battery holder for 2x AAA, 3 V, with cable without connector (batteries not included)