Kitronik Inventor's Kit for BBC micro:bit - 10 experiments, instructions in English

The Kitronik Inventor's Kit is a great introduction to programming and hardware interaction with the BBC micro:bit. This Inventor's Kit contains everything you need for 10 experiments, including using LEDs, motors, LDRs and capacitors.

To help you get started right away, an easy-to-understand tutorial is included that guides you through everything you need to know about programming the BBC micro:bit. No programming experience is required, as the tutorial guides you through the process step by step. 

The BBC micro:bit has a selection of pins located along the lower edge of its circuit board. 

Notes:

• This kit must be assembled.
• No soldering is required, and you can build your first circuit in just a few minutes!
• This kit does not include a Micro:bit.

Features:

• Carry out the 10 experiments included in the supplied step-by-step learning guide.
• All the parts needed to carry out the 10 experiments (see below) are included.
• Breaks out 21 accessible pins from the BBC micro:bit by using the Edge Connector Board for the BBC micro:bit is used.
• Small prototyping breadboard included for rapid prototyping.

Contents:

Please note: BBC micro:bit is NOT included.

• 1 x mounting plate.
• 1 x Potentiometer - vertical type (finger adjustment) 100K
  
• 1 x Finger adjustment spindle
  
• 2 x 10 mm plastic spacers
• 1 x adhesive battery pack holder
• 1 x Small prototyping breadboard
  
• 1 x Terminal connector
  
• 4 x Push button
  
• 1 x Motor
  
• 1 x Transistor
  
• 2 x Red 5 mm LED
  
• 2 x Orange 5 mm LED
  
• 2 x Yellow 5 mm LED
  
• 2 x Green 5 mm LED
  
• 1 x RGB 5 mm LED
  
• 1 x Fan blade
  
• 5 x 2.2 KΩ resistor
  
• 5 x 10KΩ resistor
  
• 5 x 47Ω resistor
  
• 1 x Edge Connector Breakout Board for BBC micro:bit
  
• 10 x Jumper wire, male to male
  
• 10 x Jumper wire, male to female
  
• 1 x 470 uF electrolytic capacitor
  
• 1 x Piezo element buzzer
  
• 4 x M3 pan-head machine screw
  
• Depending on which booklet version was supplied with your Inventor's Kit, you will have one of the following two components:
• 1 x Miniature LDRFor booklet versions before V1.7.
• 1 x PhototransistorFor booklet versions after V1.7.