QAV180 drone frame - carbon fiber, 180 mm, for FPV quadcopter

Product overview

• Carbon fiber frame with a 180 mm diagonal for FPV drones
• Four motor mounts for common brushless motors
• Supports loads of up to approximately 500 g
• Preassembled unit significantly reduces assembly time
• Power distribution and cable harness already installed

Product description

This frame forms the support system for self-built FPV drones in the 180 format. Carbon fiber makes it sufficiently rigid for fast maneuvers while keeping it light enough to maintain a reasonable balance between battery weight and payload capacity.

The kit comes as a preassembled unit with the motor connections and power distribution already prepared. This reduces assembly effort compared with assembling the drone from individual parts. The payload capacity of around 500 g is sufficient for a typical flight battery, receiver, FPV camera, and required electronics, with no spare capacity, so the total weight must be strictly observed.

Brushless motors, an ESC, a LiPo flight battery, an FPV transmitter and receiver, and a camera, as well as control software, are additionally required. The exact component requirements depend on the desired equipment level.

Safety notice

LiPo batteries must not be left unattended while charging and require special chargers. This product is intended exclusively for building prototypes and for testing and development purposes and is not approved for use in commercial flight operations. All work on the electrical installation must be carried out in compliance with the applicable drone traffic regulations; if there is any uncertainty regarding legal approval and safe operation, consult an experienced person or a qualified electrician before commissioning.